Moldy Oranges

My daughter and her family flew 1400 miles a month ago with cut up oranges in her bag.  That's ridiculous.  Sniff.  So proud.  Then there was the time in college she brought home raw potatoes because she didn't want them to go bad.  Grandma was smiling from above.  But I digress.  The inside of the oranges were moldy but the rind was still good. 

 

Molded Cranberry Sauce  
That's molded not moldy.  Kind of. 
From William-Sonoma
Serves 14 to 18
 
1 1/4 lb. fresh cranberries
1 1/3 cups sugar
2 tsp. orange zest
3/4 cup plus 2 Tbs. fresh orange juice
Pinch of salt
1 cup water
1 Tbs. unflavored gelatin

In a large saucepan over medium-high heat, combine the cranberries, sugar, orange zest, orange juice, salt and 3/4 cup plus 2 Tbs. water. Bring to a boil, then reduce the heat to medium-low and simmer, stirring occasionally, until the sauce thickens and the cranberries have burst, 25 to 35 minutes. Note: The sauce should measure no more than 3 3/4 cups.


Meanwhile, pour the remaining 2 Tbs. water into a bowl (use a small mixing bowl) and sprinkle with the gelatin. Let stand until the gelatin softens and swells, 5 to 10 minutes. 


Spoon 3/4 cup of the hot juices from the cranberries into the gelatin and whisk until the gelatin has dissolved. If you prefer a sauce with a smoother texture, transfer the remaining cranberry mixture to a food processor and pulse for 2 seconds (10 to 15 times), then proceed as directed.
 
Pour the gelatin mixture into the cranberry mixture and whisk to combine. Lightly coat the inside of a ceramic cranberry mold with nonstick cooking spray. Pour the cranberry mixture into the prepared mold and let cool to room temperature. Cover loosely with plastic wrap and refrigerate for at least 8 hours or up to overnight. 

 

To unmold, set the mold in a large bowl of warm water (115° to 120°F) so the water reaches almost to the rim of the mold. Let stand for 30 seconds, then remove the mold from the water. Carefully insert a small offset spatula or paring knife along the side of the mold. Gently pull the gelatin away from the mold to release the suction, then remove the spatula. Place a serving platter upside down on top of the mold and invert the platter and mold together. Remove the plug. Gently shake the mold until you hear the gelatin begin to release, then lift off the mold. If the gelatin does not release, replace the plug and return the mold to the warm water for 15 seconds, then repeat the steps as directed above. 

All I had to do was run the mold under warm water for seconds, unplug it and it slid right out.